ENERGY SERVICES GROUP
PENDANT HANGERS
The ESG Pendant Hanger is available for 1/2" or 3/4" Pendants
(this measurement is the I.D. of the pendant)
• A 3/4" Pendant Hanger is used for 1" to 1-1/8" O.D. pipe
• A 1/2" Pendant Hanger is used for 3/4" to 7/8" O.D. pipe
• The ESG Pendant Fixture Hanger works on any length fluorescent or LED light fixture
• The ESG Pendant Fixture Hanger works on any length fluorescent or LED light fixture
By using the Pendant Hanger you will have substantial savings in materials and labor because:
• Existing wiring can be reused
• The ground crew can install the ESG Pendant Hanger onto the fixture prior to handing off to the
installer in the lift who should be able to install the fixture within 5 minutes.
• The installer then ties in the primary wires to the fixture (three simple wire nuts)
• If leveling of the fixture is required insert a simple tie wrap into the two chains on the low hanging side
and then tightened to shorten the two chains simultaneously until level
and then tightened to shorten the two chains simultaneously until level
By using the Pendant Hanger, it eliminates the need for:
• Additional SJO or MX cable as the existing wiring can be used
• 'Bang on clamps' or beam clamps
• Time consuming measuring, cutting and installation of jack chain
• Purchasing and installing the "V" fixture hooks, usually required
SAFETY BENEFIT
• ESG Pendant Fixture Hangers increase safety to the installer as they decrease the risk of the installer or
the lift interfering with overhead obstructions.
the lift interfering with overhead obstructions.
• With the lighting circuit power disconnected, the installer and the lift only have to go to fixture
mounting height (at the end of the pendant) which is usually substantially lower than ceiling height.
mounting height (at the end of the pendant) which is usually substantially lower than ceiling height.
INSTALLATION COSTS USING AN EXISTING 12' PENDANT
| Without the ESG Pendant Hanger | WIth the ESG Pendant Hanger | |
| #12 Jack Chain12' Length x 2 @ $25/100' spool | $ 6.00 | Jack chain included with Pendant Hanger = $11.00 |
| "V" fixture hanging hook x 2 @ $50/100 | $ 1.00 | Not required for 4' fixtures, included for 8' fixtures |
| Beam Clamp x 2 @ $60.00/100 | $ 1.20 | Not required with ESG Pendant Hanger |
| 15' of SJO cord @ $0.40/foot | $ 6.00 | Not required - use existing wires |
| Labor: 45 minutes @ $50.00/hour | $37.50 | Labor: 10 minutes (5 minutes each: ground crew and installer) = $ 8.33 |
| Total Installed Cost: | $51.70 | Total Installed Cost: = $19.33 |
| (Savings of over $31.00 per fixture ! |
||
| HOW MANY FIXTURES DO YOU HAVE? |
